AcademyExtras.com
28
Jan

Epson 9900 with On-Line Spectrophotometer

QMSicon

Launch QMS

systemoverview

Select the Output Device e.g.
Epson 9900.

QMSlogo

Double Click on the QMS resource icon

proofingconditions

Select the Ink Set, the Media Type, and the Quality.
When working with an Epson 9900 you should select:
CMYKOGcmkk, SPB250 and UHQ 720×1440 (no D4D selection for error diffused proofs)
Click the Calibrate button.

calibrationtarget

The Epson 9900 engine will be selected automatically. You will see the Calibration target for CMYKOG.
Click Print.

submitted

Click OK

measured

You will see the green check mark when it is automatically measured.

After Calibration you should run a Proof Check to see that the Calibration brought the proofer to the Factory Specification.

qualitymanagement

Select the Ink Set, the Media Type and the Quality. Click the Proof Check Button

proofercheckstrip

The Proof Check Strip will show. Click Print and then OK at the next screen.

measure

Click the Measure button.

measurements

You will see the Proofer Check job. The current job will be on top.
Select the new Proofer Check and click OK.

finalproofercheck

This is a typical Proofer Check Report. All colors should extend into the Excelent window. If you are using Non-AGFA media, the results may be unpredictable.
Click Update. You can also click the Print button to keep a record of the quality.

Category : :Apogee Color / :Apogee Prepress / Proofing / QMS / Tips & Tricks